Page 1 of 1
32-bit Linux OXT Lite
Posted: Sun Dec 17, 2023 11:18 am
by richmond62
So: installed 64-bit OXT Lite on Dad's old 32-bit laptop (Debian 12, XFCE, 32-bit) and deleted the opentalk.x86-64 file, and replaced it with the equivalent file from LC 963, renaming it opentalk.x86-64 : and the thing runs!
So: absolutely no need to work on a 32-bit Linux build!
Re: 32-bit Linux OXT Lite
Posted: Sun Dec 17, 2023 11:23 am
by richmond62
The only obvious snags are these:
1. The
MessageBox does not receive focus (nor it does with LC 963).
2. These 2 buttons are invisible on the Tools palette (nor they do with LC 963):
-
- Screenshot 2023-12-17 at 13.19.44.png (18.01 KiB) Viewed 749 times
Re: 32-bit Linux OXT Lite
Posted: Sun Dec 17, 2023 11:33 am
by richmond62
I had to fart around with
root user and the
terminal to get the LC 963 'thing' from:
/home/richmond/.runrev/components/livecodecommunity-9.6.3.x86 to
/opt/openxtalk/openxtalk_x86_64
It would be a good thing if, like the LC installer, a "You Only" option were available.
For those who are 'into' some kind of XFCE Linux the trick is to open
/opt/openxtalk/openxtalk_x86_64 using
thunar like this:
Code: Select all
$ sudo thunar /opt/openxtalk/openxtalk_x86_64
Re: 32-bit Linux OXT Lite
Posted: Sun Dec 17, 2023 11:37 am
by tperry2x
richmond62 wrote: ↑Sun Dec 17, 2023 11:33 am
It would be a good thing if, like the LC installer, a "You Only" option were available.
That's fine, but is quite bad practice to have each program installed as multiple instances on a per-user basis. On a multi-user setup, you'll suddenly find all your hard disk space is gone because each user will have their own install. At approx 1.3GB each, it won't take long before a computer with a small hard drive is full up.
Better to store the program in /opt/ and have all the configurations specific to each user.
Anyway, feel free to have a go with this:
https://www.openxtalk.org/forum/viewtop ... 5246#p5246